The
solar energy is converted to electrical energy by photo-voltaic cells. This
energy is stored in batteries during day time for utilizing the same during
night time. This project deals with a controlled charging mechanism which over
charge, deep discharge and under voltage of the battery.
In this
project a solar panel is used to charge a battery. A set of op-amps are used as
comparators to continuously monitor panel voltage, load current etc.
Indications are also provided by a green LED for fully charged battery while a
set of red LEDs to indicate under charged, overloaded and deep discharge
condition.
Charge
controller also uses MOSFET as power semiconductor switch to ensure cut off the
load in low battery or overload condition. A transistor is used to bypass the
solar energy to a dummy load while the battery gets fully charged. This
protects the battery from getting over charged.
Further
the project can be enhanced by using microcontroller and GSM modem to
communicate the status of the system to a control room via SMS.
Comments
Post a Comment